Spray nozzles for PFT fine plaster spraying equipment
The choice of the spray nozzle depends on two factors:
Grain size of the material, required pump capacity

Rule of thumb grain size:
specified grain size x 3 = less than the nozzle
E.g. 3 mm x 3 = 9 => at least nozzle 10 is needed

Spray nozzles identification key
Spraying cap CONICAL SHAPEØ 16 mm spraying cap S16
Spraying capFLAT– Ø 16 mm spraying cap F16
Spraying capMortar – Ø 20 mm spraying cap M20

Spray nozzles for PFT spraying guns
Our spray nozzles for all spraying guns of the powercoat and finishing coat type are made from high-quality stainless steel.
- Ø 32 mm
- Durable
- Easy to clean
- High quality

Similarly, our nozzles for all spraying guns of the concrete primer and decorative plaster type are made from high-quality stainless steel.
- Ø 38 mm
- Durable
- Easy to clean
- High quality

Identification key for airless spray nozzles
517 – 5 = 50° nozzle angle
Rule of thumb for determining the spray width 5 x 5 = 25 cm
517 – 17 = 0.017" = 0.43 mm nozzle opening