Knauf PFT Knauf PFT

Spray nozzles Matching spray pattern guaranteed

Spray nozzle
  • Structure of fine plaster or spray nozzles

The PFT system provides the professional with a range of spray nozzles neatly matched to the application. For spraying guns, the range is divided into conical (S), flat (F) and mortar (M20). The choice of the right spray nozzle depends on the grain size and the required pump capacity. Further versions are adapted to the respective material and requirement.

With the spray nozzles for cleaning, we provide the professional with a range that is neatly matched to the application.

Details

Highlights

Spray nozzles for PFT fine plaster spraying equipment
The choice of the spray nozzle depends on two factors:
Grain size of the material, required pump capacity

Rule of thumb grain size:
specified grain size x 3 = less than the nozzle
E.g. 3 mm x 3 = 9 => at least nozzle 10 is needed

Spray nozzles identification key
Spraying cap CONICAL SHAPEØ 16 mm spraying cap S16
Spraying capFLAT– Ø 16 mm spraying cap F16
Spraying capMortar – Ø 20 mm spraying cap M20

Spray nozzles for PFT spraying guns
Our spray nozzles for all spraying guns of the powercoat and finishing coat type are made from high-quality stainless steel.
- Ø 32 mm
- Durable
- Easy to clean
- High quality

Similarly, our nozzles for all spraying guns of the concrete primer and decorative plaster type are made from high-quality stainless steel.
- Ø 38 mm
- Durable
- Easy to clean
- High quality

Identification key for airless spray nozzles
517 – 5 = 50° nozzle angle
Rule of thumb for determining the spray width 5 x 5 = 25 cm
517 – 17 = 0.017" = 0.43 mm nozzle opening

Product variants